How It Works - iOS Devices

1. Turn on the device.

Press and hold the button for 5 seconds, the device will beep and turn on.

2. Pair the device.

• Open the Find My iPhone App.

• Hold the device close to your iPhone, tap the items tab, tap ‘+’ and then Add Other Item.

• Tap Connect.

• Type a name for your device, select an emoji.

• Tap Agree to acknowledge that this item will be linked to your Apple ID.

• Tap Finish.

3. Enable Lost Mode

• Open the Find My iPhone app, tap the items tab, then tap your item.

• Under Lost Mode, tap Enable.

• Read the Instructions, tap Continue and enter a phone number or email address.

• Confirm the information, customize the lost message, and tap Activate to complete the setup.

4. Remove the device.

• Open the Find My iPhone app, tap the Items tab, then tap your item.

• Tap Remove Item and then tap Remove to complete the operation.

Note: For re-pairing the device after removing it in the app, check the (Device Button Instructions) down below.

Device Button Instructions 

1. Power on

Long press the button for five seconds, the device will beep, the light will flash three times, and the device will be turned on.

2. Device status confirmation

Double-click the device button, the device will beep, and the light will flash three times, indicating that the device is working. If the device does not ring, the device is off. Long press the button for five seconds to turn it on.

3. The device enters the pairing state again

After removing the device in the app, the device will beep and the light will flash six times, it will not shut down and will be in the pairing mode. If there is no re-pairing within 10 minutes, the device will leave the pairing state. If you want to pair a device at this time, you need to click the device button once, the device will beep, and the light will flash once. At this time, the device enters the pairing state and can be paired with the app again.

4. Factory Reset

First, remove the item from Find My app then, after the device is powered on, double-click the device button. The device will beep. Long press the device button for eight seconds until the device beeps and the light flashes three times. Release the button to complete factory reset. The device can now be paired.

5. Power off

When the device is on, press the device button 5 times in 2 seconds. The device will beep, the light will flash three times, the device will be powered off.

 

Note: If you face any re-pairing issues, follow step 4 (Factory Reset) of the Device Button Instructions and follow the instructions again.